United States
New Zealand
Bricklayer Work Pants and Boots Built for Constant Kneeling and Abrasion
Bricklaying wears out the seat, knees and pockets faster than almost any other trade, between the squatting, the grit and the constant contact with brick and mortar. You need a pant that's reinforced exactly where that load lands, and boots that shrug off mortar and lime.
Bricklayer Work Pants and Shorts
- 280GSM stretch poly-cotton canvas with DURA500 reinforcing at the kneepad pockets (WP.1) Takes a kneepad insert and holds up under constant squatting on brick and slab
- Stretch back yoke and knee panels Moves with you through the low squat and stand cycle that bricklaying repeats all day
- Double-layer reinforced pocket bags Keeps line pins, string and tape from wearing straight through the pocket
Bricklayer Work Shirts
- 185GSM stretch cotton twill (SSH.1/LSH.1) A heavier-weight fabric that resists mortar splash and brick dust better than a lightweight tee
- Triple-needle stitched seams Withstands the repeated shoulder movement of course-after-course laying
- Dual button-down chest pockets Keeps a pencil and a folding rule within reach without a separate pouch
Bricklayer Safety Boots
- Composite safety toe with a 62-durometer slip/oil/heat-resistant outsole (WB.1) Grips wet, dusty brick and mortar surfaces without the added weight of steel
- Ballistic abrasion-resistant stitching Holds up against the constant contact bricklaying puts on a boot's upper
- Integrated Poron heel insert Softens the repeated impact of standing back up from a squat all day
The stretch canvas work pants range is built specifically for the abrasion bricklaying causes. For painting or general finishing work, the painter workwear range covers similar demands with a lighter fabric.
Bricklayer Workwear FAQs
Why does the bricklayer pant reinforce the kneepad pocket specifically, rather than the whole knee area?
The WP.1's DURA500 reinforcing sits directly at the kneepad pocket and other high-wear zones, which targets the exact point that takes repeated, concentrated load from squatting, rather than adding bulk across the whole leg.
Does the bricklayer boot need a specific outsole rating for mortar and lime exposure?
The WB.1's 62-durometer rubber outsole carries an SRA slip-resistance rating alongside oil and heat resistance, which covers the wet, alkaline conditions mortar and lime create underfoot better than a boot without that specific rating.
Is a heavier fabric always better for a bricklaying shirt?
Not necessarily. The 185GSM cotton twill resists mortar splash and dust well, but it's a heavier, less breathable option than FXD's vented ripstop shirts. In consistently hot conditions, the trade-off between abrasion resistance and airflow is worth weighing against your specific site conditions.
